Rigol DM3061

RIGOL
© 2007 RIGOL Technologies, Inc.
User‟s Guide for DM3000 Series
2-37
Set Up GPIB I/O Parameter
Each device on the GPIB (IEEE–488) interface must have a unique address. You can
set the address of multimeter to any integral value between 0 and 30. The default
address is “7” when the instrument is shipped from the factory.
Press  I/O  GPIB, enter the menu shown below:
Figure 2- 39
Table 2- 27 GPIB I/O Setting Function Menu Explanation
Function
Menu
Explanation
Save all changes, back to a higher level menu.