Rigol DS1000Z Series Quick Guide

RIGOL
DS1000Z Quick Guide
6
Figure 7 Square Waveform
6. Use the same method to test the other channels. If the square
waveforms actually shown do not match that in the figure
above, please perform “Probe Compensation”.
WARNING
T
o avoid electric shock during the use of probe, please
make sure that the insulated wire of the probe is in
good condition and do not touch the metallic part of the
probe when the probe is connected to high voltage
source.
Tip
The signal output from the probe compensation connector can
only be used for probe compensation adjustment and can not be
used for calibration.

Rigol DS1000Z Series Specifications

General

Brand	Rigol
Model	DS1000Z Series
Category	Test Equipment
Language	English