7. Fail to connect PC through USB:
(1) Check if the USB data cable is correctly connected to the
oscilloscope and PC.
(2) Check if the USB data is in good condition and if needed,
restart the oscilloscope.
8. The USB disk can not be recognized:
(1) Check if the USB disk can work normally.
(2) Make sure that the USB disk being used is flash type. This
oscilloscope does not support hardware type USB disk.
(3) Make sure if the capacity of the USB disk is too large. It is
recommended that the capacity of the USB disk being
used with this oscilloscope is no larger than 8 GBytes.
(4) Restart the instrument and then insert the USB disk to
check it.
(5) If the USB disk still can not be used normally, please
contact RIGOL.
To Previous Page
Loading...
Need help?
General
