RIGOL 6 To Make Measurements
6-24 DS6000 User’s Guide
Measurement Setting
1. Source Selection
Press MEAS Source to select the desired channel for measurement
(CH1-CH4 or MATH). The color of the parameter icon under MENU at the left of
the screen will change with the source selected.
2. Measurement Range
Press MEAS Range Range to select "Screen" or "Cursor" for
measurement. When "Cursor" is selected, two cursor lines appear on the screen.
At this point, press Cursor A and Cursor B and use to adjust the positions
of the two cursor lines respectively so as to determine the measurement range.
Or, press CursorAB and use to adjust the positions of cursor A and cursor B
at the same time. Note: You can press
continuously to switch among the
cursors.
3. Delayed Measurement Setting
Specify the source A and source B in the measurement items "Delay A
→B ",
"Delay A
→B ", "Delay A →B " and "Delay A →B ".
Press MEAS Setting Type "Delay" and then press Source A and
Source B to set the two channel sources (CH1-CH4) of the delayed
measurement respectively.
To Next Page
Loading...
Need help?
General
