ring RDC10 User Manual

To keep your microSD card in good condition and to ensure your dash cam continues to function
properly, reformat it on a regular basis.
INSTALLING POWER CABLE
Route the cable through the vehicle ensuring it is hidden behind the vehicle trim and rubber door
seals where possible
Connect the mini USB connection to the Dash Cam Mount
The dash camera will automatically power on once power is available. For most vehicles this will
happen when the ignition is switched on
Connect power adapter plug to vehicle 12/24 volt accessory socket
INSTALLING DASH CAM MOUNT
RDC10 / RDC20 / RDC30
Ensure removal of plastic sticker from suction mount
Clean area for mounting to ensure it is dust/grease free
Push suction part against window and push down the locking tab
Plug power cable into mini USB connection on mount
To remove mount release locking tab and pull small silicone tab to release pressure before pulling
away from window
10

ring RDC10 Specifications

General

Brand	ring
Model	RDC10
Category	Dash Cameras
Language	English