Close it up.
Make sure that your Ethernet cable has been routed through
the hole in the bottom cover and is plugged into your Stick
Up Cam.
Then, slide the cover back into place and secure it with the
attached screw, using the star-shaped end of the included
screwdriver bit.
Snap the cover back onto the base.
Then, secure it with the included security screw, using the
star-shaped end of the included screwdriver bit.
Now your Stick Up Cam is installed and ready to use.
Final steps for wall or
ceiling mounting:
1514
02_Stick_Up_Cam_Elite_MANUAL_FR-CA_EN.indd 14-15 9/26/19 12:42 PM
To Next Page
Loading...
