Rinnai COMBI i120C User Manual

Rinnai I-Series Boiler Conversion Manual 7
3. Adjust Parameter Sengs
1. Locate the PC Board (lower le side of unit) (Figure 3).
2. Locate the red buon on the PC Board (Figure 3).
3. Press and hold the red buon for ve seconds (Figure 3).
Figure 3
PC Board
NATURAL GAS
5
Press Red Buon for
Five Seconds
PROPANE
Red
Buon
4. Press the Mode buon on the controller. Press
the (Up) or (Down) arrows to select A0.
5. Press the Select buon.
a0-A
6. Press the (Up) or (Down) arrows to select
the appropriate gas type.
• Select A for Natural Gas (NG)
• Select for Propane (LP)
Then, press the Select buon.
a0-A
7. Parameter sengs are complete. To enter normal operaon mode, press the Mode buon.
Ao-
A0-A

Rinnai COMBI i120C Specifications

General

Brand	Rinnai
Model	COMBI i120C
Category	Boiler
Language	English