Rinnai I Series Conversion Manual

Rinnai I-Series Boiler Conversion Manual 5
IMPORTANT
• Before you get started, conrm that the inlet gas pressure is between the minimum and maximum pressures
allowed for this boiler.
• If subsequent conversions are made, then a new conversion label must be placed on the boiler to accurately
reect the gas type.
CONVERSION
RATING PLATE
This Manual
The following items are supplied with the conversion kit:
CONVERSION
MANUAL
1. Items Required
Failure to correctly assemble the components according to these instrucons may result in
a gas leak or explosion.
WARNING
The gas supply shall be shut o prior to disconnecng the electrical power, before
proceeding with the conversion.
CAUTION
Do not touch any other areas on the PC board other than the described buons while
power is supplied to the appliance. Parts of the PC board are supplied with 120 volts
AC.
CAUTION
Do not touch the areas at or near the heat exchanger or hot water lines. These areas
become very hot and could cause burns.
CAUTION
Conversion Instructions
4
ORIFICE
Additional item required:
• Phillips Head Screwdriver
OUTER GASKET INNER GASKET

Rinnai I Series Specifications

General

Brand	Rinnai
Model	I Series
Category	Boiler
Language	English