12 | Neo operation guide: 11907-E 05-14
Operation of your Neo
Your controller has a built-in child lock function that requires pressing two buttons
simultaneously. This function cannot be overridden. To turn the controller on,
press PWR and OK at the same time. Pressing PWR will switch the controller off.
Fan
On start-up, the fan will start approximately
four minutes after the heater is switched on.
This delay is to reduce the amount of cold air
being pushed out into the room.
On shut-down, the fan will stop approximately
eight minutes after the heater is switched off.
This is to cool the appliance down.
Modes of operation
Your Neo has three modes of operation:
- Manual mode (set temperature)
- Auto mode (programmed timer and
temperature)
- Flame mode
IMPORTANT
The Neo is designed to run as efficiently as
possible. When in manual or auto modes, the
heater will switch itself off if the room reaches
the set temperature, i.e. in smaller rooms that
heat up quickly. When this occurs, the flame
indicator on your controller will rise and fall
every few seconds to indicate the heater is
still operational. The heater will restart again
once the room temperature falls below the set
temperature.
ALWAYS check your wireless controller before
going to bed or leaving the building to ensure
the heater has been switched off.
If you want the Neo to operate regardless
of room temperature, you can adjust the
controller to flame mode only.
Start-up
When turning the Neo on, the heater will
automatically go to the highest setting for
approximately 45 seconds—this is to establish
the flame pattern. You can adjust the heater
during this period, but there will be a 45
second delay.
Over temperature automatic shut off
The controller when operating in any of the
three modes will automatically shut down and
switch the heater off if the room temperature
exceeds 40 °C for more than three minutes—
this is a safety feature.
To Next Page
Loading...
Need help?
General
