6 | Neo operation guide: 11907-E 05-14
Do not use or store flammable
materials near this appliance.
Combustible materials must not
be placed where the heater could
ignite them.
Do not spray aerosols while the
appliance is operating. Most
contain butane gas which can
be a fire hazard if used near the
appliance.
A dedicated 240 V earthed 10 A
power point must be used with
this appliance. Do not use power
boards or double adaptors to
operate this appliance.
Do not place containers of liquid
on top of the appliance. Water
can cause extensive damage and
create an electrocution hazard.
Do not place articles on or
against this appliance.
SAFETY DEVICES
- Overheat switches: When the heater gets too hot during operation (for example; when the
air outlet louvres are blocked), the overheat safety switches will turn off the gas and will only
allow the heater to restart when it has cooled down.
- Electrical fuse: The electrical circuits are protected by a fuse.
- Flame failure sensing system: This device automatically cuts off the gas supply to the heater
in the event the heater does not ignite after several attempts—this is to prevent gas building
up inside the unit.
- Power failure: In the event of a power failure or power cut, the gas valves will automatically
close and shut down the unit.
To Next Page
Loading...
Need help?
General
