ARBOTOM
®
- Manual 21
Step 2: Insert the height above ground of the measuring level into the column “Height) in
the “Positions” datasheet.
Step 3: Insert the positions of the
sensors along the measuring
tape into the column “Pos
[..]”. Make sure the unit
chosen is the same as on the
measuring tape.
Start at the first sensor. This
sensor will have the highest
value. (For a circumference of
2,05m e.g. enter 205). Enter
the value of the other sensor
rounded to 5cm. In the sketch
Sensor 2 is located at 20cm
on the measuring tape.
In the program you will now see the position of the sensor around a perfect circle.
tape
circumference
To Next Page
Loading...