Rish DELTA VAF NX - Page 15

M K W h
V
A
K
L2 M L3 W Ø
r h
K
V
L1
L2
DM
L3
A h
SY
3.2.3.1 Resetting Parameter
The following screens allow the users to reset Max
demand parameters, Lo (Min) / Hi (Max) values of
voltage & current , Run hour, On hour, No. of Interrupts,
& all the parameters
3.2.3 Reset Parameter Selection
Reset “None” select:
Pressing “ ” key advances
to Reset Parameter
selection screen (See
Section 3.2.3). Pressing
the “ ” key will enter the
Reset option mode & scroll
through parameter and
wrapping back to none.
15
A
V
A
K
L2 M L3 W Ø
r h
K
V
M
L1
L2
DM
L3
A h
SY
Reset option “Lo” select: (Reset
Min parameters). Pressing “ ”
key will select the value and
advance to the reset all Low
parameters.
Reset option “hr” select: (Reset
ON Hour & Run Hour). Pressing
“ ” key will select the value and
will reset On hour & Run Hour.
Reset option “hi” select:
(Reset Max parameters)
Pressing “ ” key will select
the value and resets all
Max parameters.
Sys
V
K
r h
K
V
M
L1
L2
DM
A h
L3 L1 Hz P F
SY
V
Reset option “Intr” select:
(Reset Number of Interrupt)
Pressing “ ” key will select
the value and will reset
number of auxiliary supply
interruption count.
V
E
V
A
K
L2 M L3 W Ø
r h
V
M
L1
L2
DM
L3
A h
SY
Reset option “All” select:
(Resets ALL resettable parameter)
Pressing “ ” key will select
the value and advance to the
reset ALL parameters.
M K W h
L1
L2
DM
L3
SY
Pressing the “ ” key will
set the value.
Pressing the “ ” key again
will jump to the Serial
parameter Quit screen.
Reset option "d" select:
(Reset Max Demand
parameters)
Pressing " " key will
select the value and
resets all Max Demand
parameters.