16
3.2.4.1.1 Relay output Selection Menu
3.2.4.1.1.1 Limit Output
This screen is used to
assign Relay in limit output
mode.
Pressing “ ” key will assign
Limit output mode (See
Section 3.2.4.1.1.1.1).
Pressing the “ ” key will scroll through Limit or None
None Option.
if None option Selected then the relay will not
assigne to any parameter
This screen allows the user
to quit the output option
V
A
M K W h
V
A
K
r h
V
M
L1
L2
DM
L3
L3 L1 Hz P F
SY
Pressing the “ ” key will
go back to Relay output option
(See section 3.2.4.1).
Pressing “ ” key will advance
to the Output Parameter selection
(See section 3.2.4)
M K W h
V
A
K
L2 M L3 W Ø
r h
K
V
L1
L2
DM
A h
SY
E
P
A
V
A
K
r h
K
V
M
L1
L2
DM
L3
A h
SY
3.2.4. Output Option Selection Menu
This screen applies to the
Relay Output option Selection.
3.2.4.1 Configuration of Output
Pressing the “ ” key will
advance to the Quit screen.
Pressing “ ” key will select
the rEL1 Output Selection
Screen(See Section3.2.4.1.1).
Sys
E
A
V
A
K
L2 M L3 W Ø
r h
K
M
DM
L3
A h
SY
3.2.4.1.1.1.1 Assignment of Limit Output
to Parameter
This screen is for Limit output mode selection. It
allows the user to set Limit output corresponding
measured value. Refer Table 2 “Parameter for Limit
Output” for assignment.
Pressing “ ” key advance
to the Limit Configuration
Selection screen (See Section
3.2.4.1.1.1.2). Pressing the “ ”
key will enter the Limit Output
edit mode. Pressing the “ ”
scroll the values, as per Table
2: “Parameter for Limit Output”.
V
P
Sy
A
M K W h
V
A
L2 M W Ø
r h
V
L1
DM
A h
L3 L1 Hz P F
SY
P
A
M K W h
V
K
L2 M L3 W Ø
r h
K
V
L1
L2
DM
A h
L3 L1 Hz P F
SY
Pressing the “ ” key sets the displayed value &
pressing “ ” key will advance to the Limit
Configuration Selection screen (See Section
3.2.4.1.1.1.2 ).
(For detail refer to section 8.1).
Pressing the “ ” key advances to the “Trip point selection”
screen (See Section 3.2.4.1.1.1.3).
Pressing the “ ” key will enter the Limit Configuration
edit mode and pressing the “ ” key will scroll through the
modes available.
Hi - E (High Alarm &
Energized Relay)
Hi - d (High Alarm &
De-Energized Relay)
Lo - E (Low Alarm &
Energized Relay)
Lo - d (Low Alarm &
De-Energized Relay)
3.2.4.1.1.1.2 Limit Configuration Select
This screen is used to set the Limit Configuration,
four different types of configuration can be selected:
To Next Page
Loading...
Need help?
General
