32
Table 5: RS 485 Set-up Code
NOTE : Codes not listed in the table above may
give rise to unpredictable results including loss of
communication. Exercise caution when attempting to
change mode via direct Modbus writes.
Table 6: Limit Configuration Select
Code
1
0
Configuration
Hi- alarm & Energized relay
Hi- alarm & De-energized relay
Lo- alarm & De-energized relay
Lo- alarm & Energized relay
2
3
9.1 User Assignable Modbus Registers
The Multifunction Meter contains the 20 user
assignable registers in the address range of 0x1450
(35201) to 0x1476 (35239) (See Table 10).
Any of the parameter addresses (3X register
addresses Table 4) accessible in the instrument can
be mapped to these 20 user assignable registers.
Parameters (3X registers addresses ) that resides in
different locations may be accessed by the single
request by re-mapping them to adjacent address in
the user assignable registers area.
The actual address of the parameters (3X registers
addresses) which are to be assessed via address
0x1450 to 0x1476 are specified in 4X Register
0x157D to 0x1590 (See Table 11).
Baud Rate Parity Stop bit Dec imal Value
4800 NONE 1 4
4800 NONE 2 5
4800 EVEN 1 6
4800 ODD 1 7
9600 NONE 1 8
9600 NONE 2 9
9600 EVEN 1 10
9600 ODD 1 11
19200 NONE 1 12
19200 NONE 2 13
19200 EVEN 1 14
19200 ODD 1 15
38400 NONE 1 16
38400 NONE 2 17
38400 EVEN 1 18
38400 ODD 1 19
57600 NONE 1 20
57600 NONE 2 21
57600 EVEN 1 22
57600 ODD 1 23
46067 Limit 1 Off Delay
46085 Version No.
This address is used to set the De-Energizing delay between 1 to
10 .
Writing any other value will return an error.
This Address shows The firmware version of device
To Next Page
Loading...
