RITEC RPR-4000 - Page 10

RPR-4000
Operations manual
REV 8-21 10
Dimensions ............................................................................19” x 5” x 17”
(483 mm x 127mm x
432mm)
Shipping Weight ....................................................................45 pounds
(21 kg)
Auxiliary Power Connector
-12V @ 100 mA .....................................................................pin 1
+12V @ 100 mA ....................................................................pin 3
Ground ...................................................................................pin 2
Front panel connections
Input Number 1 ......................................................................Receiver input number 1
Input Number 2 ......................................................................Receiver input number 2
Output ....................................................................................Receiver output (1V P/P into
50 Ω)
Diplexer Output To Receiver .................................................Internal diplexer received
signal out
to receiver or pre-amplifier
RF Pulse Monitor ...................................................................High power pulse monitor
(-40 dB into 50 Ω)
High Power RF Pulse Output .................................................Primary RF pulser output
Voltages as high as 2850 Vpp can be present at this point during
normal operation. Only connect appropriately rated
transducers and accessories to this point.
Rear panel connections
External RF Input (CW input) ...............................................(up to 1V P/P into 50 Ω)
Trigger Out.............................................................................(positive TTL level)
RF Gate Monitor ....................................................................(positive TTL level)
Amp Gate Monitor .................................................................(positive TTL level)
Trigger Input ..........................................................................(positive TTL level)
Amp Gate Input......................................................................(positive TTL level)
Synth. Monitor (-20dB into 50 ohms)....................................(0.1V P/P into 50 Ω)
Clock Output (80MHz) ..........................................................(2V P/P into 50 Ω)
Power Supply Output .............................................................(+/-12V)
HP RF Output ................................................Rear panel amplifier output which
does not pass through the internal diplexer and/or internal attenuator.