Max. loading of the outputs:
30 V/10 mA, direct current
Connection: screened 15-core control cable
The possibility exists to access this information over the PLC interface (level 8, table 5.1 or fig. 5.1).
a) Standard mode (Level 8="0")
Communication of the enclosure internal temperature and of the fault messages is made
successively in 2 s cycle. Since this is an 8-bit parallel transmission , input signals should not be
accepted as valid in the PLC until they have been present for 0.5 s. This ensures that no invalid
input information will be evaluated in the event of signal changes at the inputs.
To Next Page
Loading...
