Temperature Controller Driver
GP-Pro EX Device/PLC Connection Manual
228
23 IP Device address
24 IR Communication speed
25 IQ Data bit configuration
26 IT Interval time
27 EB EEPROM storage mode
28 EM EEPROM storage status
29 LK Lock level 1
2A LL Lock level 2
• Setting "Use system data area" to GP-Pro EX system area result in improper
operation. Do not set "Use system data area."
• System area setting that can be used for the temperature controller is reading area size only. Please
refer to the GP-Pro EX Reference Manual for system data area.
Cf. GP-Pro EX Reference Manual "LS Area (Direct Access Method Area)"
• Please refer to the precautions on manual notation for icons in the table.
"Manual Symbols and Terminology"
• Even if non-existing address is used, there are cases when read error is not indicated. In this case,
zero (0) is kept for read out data. On the other hand, writing error is indicated.
Address Identifier Description
To Next Page
Loading...
Need help?
General
