-1-
1. I n i t i a l s e t m o d e c h a n g i n g
1.1 Entering the initial set mode
(1) Press the key to display the set data locking parameter
symbol on the measured-value (PV) display unit.
At this time, the least significant digit on the set-value (SV)
display unit lights brightly. The digit which lights brightly is
settable.
(2) Press the key to shift the digit which lights brightly up to
the hundreds digit. The digit which lights brightly shifts as
follows every time the key is pressed.
(3) Press the key to set “ ”. Pressing the key increments
numerals, and pressing the key decrements numerals.
: No initial set mode locked
(4) Hold both the (A) and (B) keys simultaneously
until appears.
Cautions
1. In order to enter the initial set mode, always set the data locking
to “ ”. Any setting other than “ ”
cannot enter the initial set mode.
2. If the controller is set to the initial set mode, all outputs are turned OFF.
3. An example of the REX-C900 is described here, but the same procedure applies to other
controllers (REX-C100, -C400, -C410, and -C700).
To Next Page
Loading...
Need help?
General
