222 • Configuring the TC Gas in Setup Mode EAGLE 2 Operator’s Manual
21. Press and release POWER ENTER RESET.
22. A screen appears that asks if you want to save the changes you have
made.
NOTE: If you entered Setup Mode and did not make any changes, the above
screen will still appear. In this case, press and release DISPLAY
ADJUST NO to proceed to exit Setup Mode and begin the EAGLE
2’s startup sequence.
23. If you do not want to save the changes, press and release DISPLAY
ADJUST NO. The unit will begin its startup sequence without saving the
changes.
If you do want to save the changes, press and release AIR ▲ YES and
continue with the next step.
24. A confirmation screen appears asking if you are sure you want to save the
changes.
25. If you want to save the changes, press and release AIR ▲ YES to save the
changes. A screen will appear for a few seconds indicating that the
changes have been saved and the unit will begin its startup sequence.
If you do not want to save the changes, press and release DISPLAY
ADJUST NO to proceed to the unit’s startup sequence without saving
changes.
SAVE ALL CHANGES
IN MEMORY?
ARE YOU SURE YOU
WANT TO SAVE ALL
CHANGES IN MEMORY?
To Next Page
Loading...
