96 • Leak Testing GX-2012 Operator’s Manual
when you are finished recording snap logs, press and release the
DISPLAY (ADJ) button. The unit will immediately return to the
Normal Operation Screen.
8. The data recorded in Snap Log Mode can be viewed in Display
Mode. See “Snap Logging Screen” on page 53 for more
information.
Viewing Snap Log Data in Leak Check Mode Operation
Snap log data can be viewed while in Leak Check Mode. If snap log
data was taken while in Normal Operation, that data will also appear.
1. Turn the GX-2012 on as described in “Turning On the GX-2012,
Leak Check Mode” on page 83.
2. Press and hold the RESET SILENCE button and then press and
hold the DISPLAY (ADJ) button and release both.
3. If no snap logs have been performed, the following screen will
appear.
Press and release the DISPLAY (ADJ) button to return to Leak
Check Mode.
4. If snap logs have been performed in either Normal Operation or
Leak Check Mode Operation, one of the following screens will
appear. LEAK CK MODE will appear in the upper left corner of
Leak Check Mode Operation data to indicate that the snap log was
taken during Leak Check Mode Operation.
2012
2
15
14:17
LEAK CK MODE
M009
2011
8
31
22:39
M023
Normal Operation Leak Check Mode Operation
Snap Log Snap Log
To Next Page
Loading...
