GX-2012 Operator’s Manual Display Mode • 51
User ID Screen
This screen always appears in Display Mode, regardless of the ID DISP
setting in the Maintenance Mode menu. Each user ID can contain up to 16
characters but only the first 8 of those characters are visible in the instrument.
Be sure that all user IDs are distinguishable from each other by viewing only
the first 8 characters. For more information, see the GX-2012 Data Logger
Management Program manual. The bottom line of the screen alternates
between YES/ENT., the current user ID, and NO /DISP. Uppercase letters,
numbers, asterisks (*), dashes (-), and a blank space are available characters.
The GX-2012 can store 128 user IDs.
Use this screen to identify or change the user. The user ID provides a way to
identify the user during a data logging session. The user ID is saved to the
data logger for that session when you turn off the GX-2012 or change users
during operation. This allows you to change the user ID during operation and
have each user ID that was used during an operating session saved for the
corresponding data.
NOTE: As shipped from the factory, the user ID on this screen is shown as -
- -- -- -- -- -- until you enter this screen and select a user ID.
To change a user:
1. After entering Display Mode and proceeding to the User ID screen, press
and release the POWER ENTER button. The bottom line of this screen
alternates between YES/ENT., the current user ID, and NO /DISP.
To Next Page
Loading...
