RMF Systems CMS 2 - Data Logger

12
As a policy of continual improvement, RMF reserves the right to alter the specification without prior notice.
201.028 REV 1 Date of Issue: 18 June 2018
4.2.2 Data Logger
The CMS includes a built-in data logger, which adds the facility to log and timestamp test results locally within an
internal memory, even when not connected to a computer.
− Test logging is determined by the log settings (see section 6.3.3).
− Each log entry is time-stamped and contains the CMS serial number, so that it can be identified later.
− The CMS memory has space for around 4000 log entries. When full, the oldest log entry is overwritten.
See section 6.3.1 + 6.3.2 for details of how to download the test log via bespoke windows based software.
4.2.2.1 Data Transfer via USB Stick
The U version of the CMS allows direct download via a USB memory stick. With the CMS powered up, plug the
USB stick into the USB connector at the top of the unit.
The screen / indicator will turn yellow briefly as it writes the test records to the USB stick. When complete, it will
turn green and the stick can be removed. If there is a problem with the data transfer (stick full or corrupt or not
recognised) then the screen / indicator will turn red. If this happens the operator can remove the stick and try
again with an alternative.
The USB stick provided with the unit is pre-formatted for the transfer. Other USB sticks may need to be re-
formatted (FAT32).
PLEASE NOTE: The USB option is not to be used for anything other than a memory stick
for results download. Any subsequent use other than that intended may cause damage
to the device