RMF Systems CMS 2 - Further CAN-Bus Information; Example Walk through

65
As a policy of continual improvement, RMF reserves the right to alter the specification without prior notice.
201.028 REV 1 Date of Issue: 18 June 2018
11.2 Further CAN-bus Information
11.2.1 Example Walk through
Real applications will generally have an existing CAN network, but in this chapter we show how the CMS can be
connected to a PC using a USB: CAN adaptor.
The adaptor used in this example is the ``PCAN-USB’’, available from Peak System Technik GmbH or a distributor.
We also need to make up a special cable to connect this to the CMS.
Figure 11.1 PCAN-USB CAN-bus to USB Adaptor
11.2.1.1 Equipment Required
− CMS with CAN-bus capability
− PCAN-USB USB:CAN Adaptor
− CMS-USBi interface for initial CMS setup
− PC with USB ports running Windows
− Special made-up CAN-bus cable detailed below
− 12 or 24 Volt DC power supply