ROBBE Telemetry-Box - Programming Menu

Telemetry-Box 2.4 GHz FASSTest
®
11
14. MAIN SCREEN PROGRAMMING MENU
Holdingboththe"+"and"-"buttonspressedintakesyou
from the Display menu to the Programming menu.
14.1 SPEECH MENU
>SPEECH
DISPLAY
SENSORSETuP
SENSORREGISTER
MODELSELECT
SPEECHSELECT
In the "Speech" menu the parameters for speech output
canbeadjusted:
Pause:
Timeadjustmentfortheintervalbetweenspeechmessa-
ges.
Adjustment range: 5-30 seconds.
Repeat:
At this point you can set whether the speech message is to
be repeated or not.
Volume:
Volume setting for speech output and Vario tones. Howe-
ver, volume can also be altered from the Display menu. All
you have to do is hold the "ENT." button pressed in (see
page 10, chapter 13).
Adjustment range: 0-7
>PAuSE 10 S
REPEAT ON
VOLuME 6
14.2 DISPLAY MENU
Inthe"Display"menuyoucan adjust theparametersfor
the screen display:
Button beep:
Adjustmentofbuttonbeepandwarningsoundvolume.
Adjustment range: 0-7
LCD contrast:
Adjustmentofscreencontrast.
Adjustment range: 0-10
LCD backlight:
Adjustmentofscreenbacklightduration.
Adjustment range: 10-Unlim (always on) seconds
>BuTTON BEEP 3
LCD CONTRAST 0
LCD BACkLIGHT 10 S