ROBBE Telemetry-Box - Binding the Telemetry-Box

Telemetry-Box 2.4 GHz FASSTest
®
7
9. BINDING THE TELEMETRY-BOX TO THE
TRANSMITTER
BINDING
•Ensurethatthereceiverinthemodelisboundtothe
RC system transmitter.
•PlacetheRCsystemreceiverclosetotheTelemetry-
Box (approx. 10 cm).
•NowswitchtheTelemetry-Boxon.
• Locate the "LINK/MODE" button on the telemetry
receiver and hold it pressed in for about five seconds;
this activates transmit mode on the telemetry receiver.
•ThemonitorLEDonthereceivernowashesredand
green.
•Thetelemetryreceiverisboundbyholdingthe"LINK"
button on the Telemetry-Box pressed in for about three
seconds.ThemonitorLEDashesredandgreen.
•NowswitchofftheTelemetry-Boxandthereceiverin
order to save the binding information.
•WhenyouswitchonthereceiverandtheTelemetry-
Box again, the green LED on the Telemetry-Box lights
uptoconrmthelinkbetweenreceiverandTelemetry-
Box.
Basically the Telemetry-Box can be connected to R7008SB
and R6308SBT receivers.
ToensurethattheTelemetry-Boxcanpickupdatafromthe
receiver, the receiver must first be bound to the transmitter.
The method of binding is described in the instructions sup-
plied with your transmitter and / or receiver.
Important:
The R6308SBT and R7008SB telemetry receivers only
transmit the telemetry data available to them if the recei-
vers are bound to a FASST / FASSTest transmitter.
Thepurposeofthisistoreducebackgroundelectricalin-
terference and unnecessary frequency use of the 2.4 GHz
band.
Note:
The Telemetry-Box stores the last two binding processes.
When you switchmodels, this makesit possible to con-
tinue to use the Telemetry-Box without having to re-bind.
Monitor LED
„LINK“- Taste
FASST steering channels
FASSTest Telemetry Data