Roberts iStream 3 - Network Connection Management; Changing Network Profiles

17
Connectingtoyourcomputernetwork-cont.
If you have followed the steps on the preceding pages successfully, your radio will have connected to your
router, and then made a connection to the Internet and set its clock. You can then listen to radio stations
via the internet and use the other features of your radio (see page 23 onwards).
Changingthenetworkconnection
In the sections above, you chose how your radio would be connected to your network, using a WiFi
connection. From time to time, you may nd that you need to connect to different computer networks. The
Network Settings menu allows you to change your radio’s network settings, scan for an alternative wireless
network, or to manually congure the network parameters.
The steps outlined below describe how you can do this - see also the section 'Network proles' on page 65.
If you have no need to do this, however, please skip to page 23.
ConguringtheradiotouseanalternativeWiFiconnection
1. From the Network Settings menu select 'Network wizard'. This will present you with details of any WiFi
networks that are found. Scroll down the list using the Tuning/Select control to the desired network
name. Press the control to select this network.
The radio will then use its WiFi system to communicate with the network. Depending on the settings for
the new network you may need to enter an encryption key (see pages 15-16). By default the radio will
then acquire an IP address and other network settings from the network's router using DHCP (Dynamic
Host Conguration Protocol).
Last listened
Station list
Recall from Preset
Save to Preset
System settings
Main menu
Internet radio
Equaliser
Network
Time/Date
Backlight
Inactive Standby
Language
System settings
Network wizard
PBC Wlan setup
View settings
Wlan region
Manual settings
NetRemote PIN Setup
Network settings
Network settings
Network wizard
Scanning...
DAB
30