Roberts iStream 3 - Audio Connections; Headphone Socket Usage; Auxiliary Input Usage

62
DisplayandAudio.
Headphone socket
A 3.5mm Headphone Socket located on the top of your radio is provided for use with
headphones. Inserting a plug automatically mutes the internal loudspeaker. Please be
aware that the sensitivity of headphones can vary widely. We therefore recommend setting
volume to a low level before connecting headphones to the radio. IMPORTANT: Excessive
sound pressure from earphones and headphones can cause hearing loss.
To prevent possible hearing damage, do not listen at high volume levels
for long periods.
Auxiliary input socket
A 3.5mm Auxiliary Input socket located on the top of your radio is provided
for connecting the audio signal from an external audio source such as an
MP3 or CD player.
1. Connect a stereo lead from the headphone output of your MP3 or CD
player to the Aux In socket located on the top of the radio. Typically this
lead will have a 3.5mm stereo plug at both ends.
2. Switch on your radio and press the Mode button until 'AUX in' mode is
shown on the display.
3. Press 'play' on the connected audio device. If you are using its headphone
output for the connection, set its volume control to a level of somewhere
between two-thirds and maximum (the objective is to get a strong audio
signal but without too much distortion). Then adjust the volume on the
radio as required.
Note, if using an iPod as the sound source, you may need to set its output
to maximum to get an adequate audio signal level.
4. After use, disconnect your player in order to listen to your radio
conventionally.
Pair
Sleep
Pair
Sleep
DAB
30