Roberts iStream 3 - Playlist and Server Management; Clearing the Playlist; Playing Saved Playlists; Pruning UPnP Servers

40
MusicPlayer.
Shared media
USB playback
My playlist
Repeat play: Off
Shuffle play: Off
Clear My playlist
Music player
Clear My playlist
Remove all from My playlist
Shared media
USB playback
My playlist
Repeat play: Off
Shuffle play: Off
Clear My playlist
Music player
USB playback
My playlist
Repeat play: Off
Shuffle play: Off
Clear My playlist
Prune servers
Music player
Prune servers
Prune shared media
wake on LAN servers?
Clearingtheplaylist
1. Press Menu. To clear the whole playlist choose 'Clear My playlist' and then
choose 'YES'. If you do not wish to clear the playlist choose 'NO'.
Playingyourplaylists
1. Press Menu. Choose 'My playlist'.
2. To play the playlist from a particular track, rotate Tuning until the desired track
is highlighted then press the control to start play.
3. While playing from the playlist, you can use this function to jump to a particular
track within the playlist. While playing from the playlist, you may add additional
tracks or albums or remove specic tracks (please see the preceding page).
Prune servers
Your radio stores details of UPnP servers that it has seen via its network connection
in its internal memory. If you use the radio at different locations you may nd that
there are servers listed by the radio that you are no longer interested in. The prune
servers function allows only active UPnP servers on the currently connected network
to be shown when selecting 'Shared Media' from the Music Player menu.
1. Press Menu. Choose 'Prune servers'. To remove servers that are no longer
required choose 'YES'. If you do not wish to prune servers choose 'NO'.
Wake On LAN
If you are using a computer as a UPnP server for playing your music les via your
radio, you may not wish to keep that computer operating when you are not listening
via your radio. If your computer is suitably congured, it can either shut down, or
enter a Standby or hibernation state when it is not being used.
Your radio can wake up a computer which has shut down using a Wake On LAN
command via the network provided that the radio has previously connected to a
UPnP server application on that computer. A computer which is not currently active
will be shown with a question mark in the list of UPnP servers. Many computers
will not respond to Wake On LAN commands from the radio in all modes, and may
require software, device driver, BIOS, hardware or router conguration changes for
this function to operate. Failure of a computer to respond to Wake On LAN is not
considered a fault of the radio.
?DAD: Les:
?JENNY: Jenny’s music
HOME_PC: Mum’s music
Shared media
DAB
30