Roberts Splash! - FM Radio Operation; Auto-tuning and Reception Improvement

If you need any further advice, please call our Technical Helpline on :-
020 8758 0338 (Mon-Fri)
14
Operating your radio - FM auto-tune
1. Fully extend the wire aerial located on the rear of your radio. Place the
wire antenna so that it is as straight as possible extending either above
or below the radio.
2. Press the On / Off button to switch on your radio and press and release
the Band button until the FM mode is selected.
3. Press and release the Select button until 'Auto tune' appears on the
display.
4. Press and release the Tuning Up button to cause your radio to search
from low frequency to high frequency and to stop automatically when it
fi nds a station of suffi cient strength.
5. After a few seconds the display will update. The display will show the
frequency of the signal found. If the signal is strong enough and there is
RDS data present then the radio may display the station name.
6. To fi nd other stations press and release the Tuning Up button as before.
7. Press and release the Tuning Down button to cause your radio to search
from high frequency to low frequency and to stop automatically when it
fi nds a station of suffi cient strength. When the end of the waveband is
reached your radio will recommence tuning from the opposite end of the
waveband.
8. Adjust the Volume to the required setting.
9. To switch off your radio, press the On / Off button.
Note:
If you fi nd that FM reception is poor, try repositioning the wire aerial, up
or down or side to side.
7
4,6
2
2,9
8
8
3
87.50MHz FM
Auto tune <
FM
<
Searching...
FM
<.
Searching...
FM
>.