If you need any further advice, please call our Technical Helpline on :-
020 8758 0338 (Mon-Fri)
8
Operating your radio
1. Fully extend the wire aerial located on the rear of your radio (inside the
battery compartment). Place the wire antenna so that it is as straight
as possible extending either above or below the radio.
2. Press the On / Off button to switch on your radio. The display will
show 'Welcome to Digital Radio'. After a short time the current time
will appear on the display.
3. If this is the fi rst time the radio is used a scan of Band III DAB channels
may be carried out. If the radio has been used before, the last used
station will be selected.
4. When fi rst switched on, the fi rst station in the list of stations found will
be played. The display will show the station name on the upper line
of the text display and broadcast information on the lower line.
5. If the station list is still empty after the scan operation or if there are no
signals found it may be necessary to relocate your radio to a position
giving better reception, and then repeat the scan using the Auto-tune
facility (see 'Finding new stations' on page 11).
Note: that radio station name and frequency displays shown in this user
guide may differ from those that you see on your radio. Broadcasters may
change radio station names that are transmitted, and the frequencies
used for DAB and FM radio stations may not be the same in all parts of
the country.
2
Welcome to DAB10
Welcome To
Digital Radio
To Next Page
Loading...