17
Scan sensitivity setting - FM
Your radio will normally scan for FM broadcasts which are strong enough
to give good reception. However, you may wish the Auto-scan function
to also be able to fi nd weaker signals, possibly from more distant radio
transmitters. Your radio includes a local / distant option for the Auto-scan
function.
1. Press the On / Off button to switch on your radio.
2. Press and release the Band button until the FM mode is selected.
3. Press and hold the Menu button.
4. Press the Tuning Up or Down buttons until 'FM Scan Zone' shows
on the display. Press and release the Select button to enter the scan
sensitivity adjustment menu.
5. Press the Tuning Up or Down buttons to switch between 'Local'
(Strong stations only) and 'Distant' (All stations) options on the lower
line of the display. The Distant option will allow the radio to fi nd weaker
signals when scanning.
6. Press and release the Select button to confi rm your selection. The
Local or Distant setting is stored in the radio and remains in force until
changed or until a System Reset.
Note: The initial setting (out of the box, or after a System Reset) causes
the radio to ignore weaker (or more distant) signals.
1
4,5
4,5
4,6
3
2
FM
FM Scan Zone
FM
FM Scan Zone
Local
FM
*
FM Scan Zone
Distant
FM
To Next Page
Loading...