15
Manual tuning - FM
1. Fully extend the wire aerial located on the rear of your radio. Place
the wire antenna so that it is as straight as possible extending either
above or below the radio.
2. Press the On / Off button to switch on your radio and press and release
the Band button until the FM mode is selected.
3. Press and release the Select button until 'Manual tune' appears on
the display.
4. Press and release the Tuning Up or Down buttons to tune to a station.
The frequency will change in steps of 50kHz.
If the radio is tuned to a station of suffi cient signal strength with RDS
information present, then the display may change to show the station
name.
5. When the waveband end is reached the radio will recommence tuning
from the opposite waveband end.
6. Set the Volume to the desired setting.
7. To switch off your radio press the On / Off button.
Note:
If you fi nd that FM reception is poor, try repositioning the wire aerial, up
or down or side to side.
4
4
2
2,7
6
6
3
87.50MHz FM
Manual tune <
FM
>
87.50MHz FM
FM
To Next Page
Loading...