Finding new stations - DAB+
Should you wish to use your radio for DAB+ reception in a new location,
or if no stations were detected during the initial scan, you can follow this
procedure to allow your radio to fi nd out which DAB+ radio stations are
available.
1. Ensure that the telescopic antenna is extended, and then press the
Mode button as needed to select DAB+ mode.
2. Once in DAB+ mode press the Menu button.
3. Rotate the Tuning/Select control until 'Local scan' is highlighted on
the display.
4. Press the Tuning/Select control to initiate the scan. The display
will show 'Scanning' and your radio will perform a scan of the DAB+
frequencies. As new stations are found the station counter will increase
and stations will be added to the list. The bar graph indicates the
progress of the scan.
5. To carry out a full scan of the entire DAB+ band rotate the Tuning/
Select control until 'Full scan' is highlighted on the display.
6. Press the Tuning/Select control to initiate the scan. The display will
show 'Scanning'. As new stations are found the station counter on the
right hand side of the display will increase and stations will be added
to the list. The bar graph indicates the progress of the scan.
Due to the larger number of DAB+ channels scanned, the full scan
will take longer than the local scan.
3-6
2
45
1
To Next Page
Loading...
