Roberts WM-202 - Dynamic Range Control Settings - DAB

Dynamic Range Control settings - DAB+
Dynamic Range Control (also known as DRC) can make quieter sounds
easier to hear when your radio is used in a noisy environment by reducing
the dynamic range of the audio signal.
1. Press the On/Off button to switch on your radio.
2. Press the Mode button as needed to select DAB+ mode.
3. Press the Menu button to enter the DAB+ menu list.
4. Rotate the Tuning/Select control until 'DRC' is highlighted on the
display.
5. Press the Tuning/Select control to enter the DRC adjustment mode.
The current DRC setting will be indicated with an asterisk.
6. Rotate the Tuning/Select control to highlight the required DRC setting
(the default is Off).
DRC Off - DRC is switched off, Broadcast DRC will be ignored.
DRC high - DRC is set as sent by broadcaster.
DRC low - DRC level is set to 1/2 that sent by broadcaster.
7. Press and release the Tuning/Select button to confi rm the setting.
Note: Not all DAB+ broadcasts use the DRC function. If the broadcast
does not provide DRC information, then the DRC setting in the radio will
have no effect.
4-7
1
2
3
47