Robertshaw Smart Sense Series - Page 10

10
Theswitchesmustbesetcorrectlyforeachsystemconguraon.Followthese
steps:
1. Review the settings in Table 1.
2. Read the switch descriptions.
3. Mark or write down the switch positions that you will use.
4. Inthefiguresthatfollow,findthewiringdiagramthataccuratelydescribes
yourequipment.
5. Reviewtheswitchsettingsnexttothewiringdiagram.Ifthereareany
differencesbetweenthatlistandyourselections,reviewyourlist.Becertain
you have the correct wiring diagram and choices for switch positions.
The ModBus and TT terminals will be described later in this manual.