To Next PageTo Next Page
Need help?Do you have a question about the RoboGuard TRX005 and is the answer not in the manual?
General| Brand | RoboGuard |
|---|---|
| Model | TRX005 |
| Category | Security System |
| Language | English |
Instructions for installing the Roboguard unit.
Setting up the beam array for optimal performance using walk-test.
Setting up Roboguard to work best in specific locations by activating different modes.
Adjusting the beam range of the Roboguard.
Identifying and rectifying constant false alarms.
Narrowing the angle of view or blocking moving objects.
Basic maintenance to keep the system performing optimally.
Information on Roboguard battery life and replacement.
A detailed breakdown of Roboguard components.
Recommended installation using mounting brackets.
Components included in the HQ kit.
Understanding the lights and signals of the HQ receiver.
Initial setup procedure for the HQ.
Programming the first four Roboguards into the HQ.
Programming additional Roboguards into the HQ.
Programming remote controls for the HQ.
Configuring output ports for connection to alarm panels.
Procedure for cloning a Roboguard remote transmitter.
Instructions for operating the timer relay.
Mounting and wiring the Roboguard keypad.
Programming Roboguards into the keypad.
Programming remote transmitters for the keypad.
Configuring output ports for the keypad.
Overview of the uRx receiver's functions and uses.
Connecting and installing the uRx receiver.
Wiring connections for the uRx receiver.
Learning Roboguard codes for the uRx device.
Configuring DIP switches on the uRx device.
Using uRx and uTx as a repeater station.
Wiring diagram for the repeater station.
Functions and applications of the Universal Transmitter (uTx).
Configuring the uTx unit to function as a repeater.
Setting up the uTx as a universal transmitter.
Programming Roboguard or Remote codes into the uTx.
Method to determine zone inputs for existing sites.
Purpose of the LED indicator unit.
Positioning and installing the LED indicator unit.
Wiring connections for the LED indicator unit.
Information on the 12 volt power supply unit.
Wiring instructions for connecting a siren to the power supply.
Entering programming mode on the HQ via the power supply.
