Robomow RC306 User Manual

35
EN
6.4.1.4 Area – Update the size of the lawn in case it has been changed.
• Press the ‘Setting’ button 4 times until the Area icon is blinking.
• Scroll to change the area and press ‘OK’ toconrm.
• Ifmorethanonezoneisdened,thenrstscrolltoselectthezoneyouwanttoeditandsetthearea
for that zone as described above.
Names of zones are as follows:
L1 – Main Zone
L2 – Separated Zone A
L3 – Separated Zone B
A1 – Sub-Zone 1
A2 – Sub-Zone 2
A3 – Sub-Zone 3
A4 – Sub-Zone 4
• The SUP value stretches lawn’s area size beyond the recommended lawn area size setting (“Maximum”
vs “Recommended” lawn size in model’s spec). ‘Maximum Lawn Size’ represents ideal mowing
conditions:atlevellawn,simplerectangularshape,noobstacles,noadditionalzones,andmodest
lawn growing pace.
• TheSUPvalueisonlyavailableforselectionifnoadditionalzonesaredened.
• If either Mowing Frequency or Inactive Time settings are altered after the Area has been set to SUP,
then the Area setting will be automatically decreased to the next lower value.
6.4.2 Advanced Settings
The Advanced Settings are additional menu options that are not changed very often and thus are not included
in the Basic Settings.
• To change any option/feature in the Advanced Settings, press the ‘Settings’ button continuously for 3 Sec.
• Menu ‘P001’ is displayed. Use the arrows to scroll to the setting you want to change, and then press OK.
• Use the arrow button to change the setting and press OKtoconrm.
• Scroll to change additional menu options or press STOP to go back to the main display.
Below are the Advanced Settings options:
Screen Seng Descripon Opons
P001
Mowing
Frequency
(Default = 2)
• Controls the frequency of mowing cycles in a particular
zone of your lawn.
• The default mowing frequency is Medium (equivalent to two
mowing cycles in a week). It means that Robomow will complete
the entire mowing of your lawn twice a week.
• The numbers in the menu represent the following values of
mowing frequency:
1 – LOW (one mowing cycle in a week)
2 – MEDIUM (two mowing cycles in a week)
3 – HIGH (equivalent to daily mowing)
• The ‘Mowing Frequency’ option is only available for zones where a
basestationisinstalled.Ifyouhavedenedatleastoneseprated
zone with a base station (see menus P013 and P014), then you
will be prompted to select the relevant zone before changing the
setting (L1 stands for the Main Zone, L2 stands for Separated
Zone A, etc.)
• During off-season when the growth rate of the grass is slower,
it is recommended to change the Mowing Frequency to ‘LOW’.
This resting period helps the grass and prolongs the lifetime of
the mower.
• Grass growth rate changes during the year (depending on
temperature, grass type, fertilizing etc.).
• High fertilization and favorable weather conditions may cause the
grass to grow faster. In such cases, set the ‘Mowing Frequency’
option to High.
1/2/3

Robomow RC306 Specifications

General

Type	Robotic lawn mower
Cutting width	280 mm
Cutting system	-
Recommended lawn area	600 m²
Maximum cutting height	60 mm
Minimum cutting height	15 mm
Grass collecting volume	- L
Battery type	LiFePO4
Power source	Battery
Charging time	1 h
Battery voltage	26 V

Weight and Dimensions

Depth	460 mm
Width	630 mm
Height	210 mm
Weight	11400 g