To Next Page
A
anthony49Aug 31, 2025
What to do if my Robomow RM400 & Base Station Lawn Mower says 'Peg base then press GO'?
- RRiley SimmonsAug 31, 2025
If your Robomow Lawn Mower displays 'Peg base then press GO', fasten the base in place using the two stakes.
What to do if my Robomow RM400 & Base Station Lawn Mower says 'Peg base then press GO'?
If your Robomow Lawn Mower displays 'Peg base then press GO', fasten the base in place using the two stakes.
Why does my Robomow RM400 & Base Station Lawn Mower say 'Close cover'?
If your Robomow Lawn Mower displays 'Close cover', and the bumper cover is not in place, ensure short or slanted obstacles are protected by the perimeter wire. Press the bumper cover downwards until it clicks into place.
What to do if my Robomow RM400 & Base Station Lawn Mower says 'Wire outside'?
If your Robomow Lawn Mower displays 'Wire outside', move the wire towards the inner side of the lawn, avoiding areas with steep slopes. Fill any holes or pits in the ground and increase the cutting height.
What to do if my Robomow Lawn Mower displays 'Rain sensor disconnected'?
Press ‘GO’ to confirm.
Why does my Robomow RM400 & Base Station Lawn Mower ask for 'Time and date'?
If your Robomow Lawn Mower displays 'Time and date', set the real time clock (day and hour) and the date.
What does 'Time completed' mean on my Robomow RM400 & Base Station Lawn Mower?
If your Robomow Lawn Mower displays 'Time completed', connect it to the charger if all mowing has been completed for the day.
What to do if my Robomow RM400 & Base Station Lawn Mower says 'Start elsewhere'?
Manually drive/carry the mower away from this particular area and restart operation. Check to ensure the mower is not stuck, allowing the drive wheels to slip. Check the ground for holes or indentions where the mower has stopped and fill it with dirt and level off. Check the drive wheels are free to rotate and nothing blocks them. Remove the mower away from this particular point and restart operation.
Why does my Robomow RM400 & Base Station Lawn Mower get stuck in place?
If your Robomow Lawn Mower is stuck in place, check the ground for any holes or indentations where the mower might have stopped, especially near the perimeter wire, and fill them with dirt to level the surface. Also, make sure the area is not too sloppy and work in dry conditions. Check that the perimeter wire is not too close to the edge, and adjust if necessary. Ensure the mowing deck is not set too low.
What to do if my Robomow RM400 & Base Station Lawn Mower shows a 'Low battery' message?
If your Robomow Lawn Mower displays 'Low battery', manually drive the mower using the remote control or carry it to the Base Station for charging. To prevent this in the future, ensure there is at least 16 hours between scheduled operations to allow sufficient charging time.
How do I fix a 'Check wire' error on my Robomow RM400 & Base Station Lawn Mower?
If your Robomow Lawn Mower displays 'Check wire', inspect and repair any loose, poor, or corroded connections in the perimeter wire. Use only the waterproof connectors supplied in the box for reliable electrical connections. Ensure the perimeter wire does not exceed 500m in length; if it does, divide the area into two separate zones.
General| Brand | Robomow |
|---|---|
| Model | RM400 & Base Station |
| Category | Lawn Mower |
| Language | English |
