Appendix F Suggestion of Mechanical LiDAR Mount
Please make sure the surface of platform used for mounting LiDAR is smooth as possible.
Please make sure the locating pin on the mount surface do exceed 4mm high. The
material of the mount platform is suggested to be aluminum alloy in order to thermolysis.
When the LiDAR is installed, if there is a mounting contact surface on the upper and
bottom sides of the LiDAR, make sure that the spacing between the mounting surfaces is
greater than the height of the LiDAR to avoid squeezing the LiDAR.
When the LiDAR cable is routed in the mount device, please keep the cable a little slack,
not too tense.
To Next Page
Loading...