Robur M40 - Page 13

Features and technical data
Installation, use and maintenance manual – M gas unit heater
13
1
cascade and also resetting any locking.
The weekly programming includes 3 adjustable tempera-
ture levels and daily times slots.
The main functions are:
▶ Multilingual interface.
▶ Gas unit heaters cascade system management (up to
10).
▶ Hourly programming on a weekly basis on 3 temper-
ature levels.
▶ Diagnostics.
▶ Reset.
▶ Gas unit heater data display and parameters setting.
▶ Space heating and summer ventilation setpoint set-
ting.
▶ Summer ventilation mode activation.
For further details and diagrams see the instruction sheet
of the digital chronothermostat OCDS008.
1.4.6 OSWR000 Genius software for remote
management of gas unit heaters
This is a software that allows, through the OTRG005 ther-
moregulators, to centralize the management of up to
100 gas unit heaters, allowing them to be freely divid-
ed into zones, for an even more personalized heating
management.
If the PC on which the software is installed is accessible
remotely, the software allows remote management of
the whole heating system from multiple devices, as well
as sending emails to report any anomalies to the gas unit
heaters or to the heating system.
The main functions are:
▶ Centralized system to control up to 100 gas unit heat-
ers.
▶ Division of gas unit heaters into zones, up to 10
dierent zones.
▶ Independent or centralized gas unit heaters control.
▶ Remote control of the system from multiple devices.
▶ Diagnostics, also by email.
▶ Reset.
▶ Gas unit heater data display and parameters setting.
▶ Space heating and summer ventilation setpoint set-
ting.
▶ Summer ventilation mode activation.
For further details and diagrams see the Genius software
instruction sheet for remote control of the OSWR000
generators.
1.4.7 External request
The appliance may also be controlled via generic enable
devices (e.g. thermostat, timer, switch, contactor...) tted
with voltage-free NO contact.
For managing the request signal (Z9 contact), Robur pro-
vides as optional dierent models of thermostats and
chronothermostats.
For a list of thermostats and chronothermostats available
as optional, see Paragraph 1.4.8 p.13 .
For further details and diagrams see Paragraph
4.4.2 p.24 .
1.4.8 Other optional thermostats and
chronothermostats
For managing the request signal (Z9 contact), Robur pro-
vides as optional dierent models of thermostats and
chronothermostats, listed below.
▶ Room thermostat with ON/OFF switch (optional
O12301035)
▶ Sealed room thermostat IP55 (optional O12301025)
▶ Digital programmable chronothermostat (optional
OCDS005)