28
Appliance commissioning
Warning!
This boiler can only be used for domestic hot
water and indoor heating!
The gas boiler was designed for inside room
installation according to the current laws and
regulations so cannot be installed and used
outdoors. If installed in outdoor environment,
it may not work and can be damaged!
Appliance should only be installed on a flat,
firm wall that can support the weight of the
boiler, also ensure the wall surface is not
combustible.
Note:
When using for the rst time, the water tank
should be lled with water. Therefore, before
fixing the flue, 1/4 litre of water should be
poured into the flue outlet (see diagram
below).
Warning!
Insufficient water in the tank can cause the
appliance to smoke for a short time.
The boiler heats the heating water/ hot water/
domestic hot water (DHW) to a certain
temperature. Before supplying heating/
domestic hot water to the users, the boiler
should be connected to a heating supplying
network, heat dissipation device and/ or
domestic hot water supplying network which
match the function and capacity of the gas
boiler. Before connecting the gas boiler to the
system, please ask the installer/engineer to
make the following operation:
a). Heating system pipe line must be
completely rinsed and cleaned. Any residues
left in the pipe will affect the appliance’s
operation.
b). Check if the current gas type is suitable for
the gas boiler. Check the technical data of the
applicable gas type in the packing instruction
and data plate to see if it is consistent with the
current gas type
c). Check if the ventilation flue pipe is
applicable and if there are any blockages. The
appliance cannot be connected to a public
chimney. The gas boiler and the flue pipe
connector can only be installed after all the
above steps are carried out.
To Next Page
Loading...
