ROC COMBI HE 2802 - Advice for the Installer

5
Advice for the installer
The installation and first ignition of the
boiler must be performed by qualified
personnel in compliance with current
national regulations regarding installation,
and in conformity with any requirements
established by local authorities and public
health organizations. After the boiler
has been installed, the installer must
ensure that the end user receives the
declaration of conformity and the operating
manual, and should provide all necessary
information as to how the boiler and the
safety devices should be handled.
This appliance is designed to produce
hot water for domestic use. It should
be connected to a heating system and a
distribution Network for domestic hot water,
both of which must be compatible with its
performance and power levels.
The use of the appliance for purposes other
than those specied is strictly forbidden .The
manufacturer cannot behold responsible for
any damage caused by improper, incorrect
and unreasonable use of the appliance or by
the failure to comply with the instructions
given in this manual.
Installation, maintenance and all other
interventions must be carried out in
full conformity with the governing legal
regulations and the instructions provided by
the manufacturer. Incorrect installation can
harm persons, animals and possessions; the
manufacturer shall not be held responsible
for any damage caused as a result.
The boiler is delivered in a carton. Once
you have removed all packaging, make sure
the appliance is intact and that no parts
are missing. If this is not the case, please
contact your supplier.
Keep all package materials (clips, plastic
bags, polystyrene foam etc.) out of reach of
children as it may present a potential hazard.
In the event of a fault and/or malfunction,
turn the appliance off, turn off the gas and
do not attempt to repair it yourself. Contact
a qualied professional instead.
Before any maintenance or repair work is
performed on the boiler, make sure you have
disconnected it from the electricity supply
by switching the external switch to the “OFF”
position and removing the fuse.
All repairs, which should only be performed
using original spare parts, should be carried
out by a qualified professional. Failure to
comply with the above instructions could
compromise the safety of the appliance
and invalidate all liability on the part of the
manufacturer.
In the event of any maintenance or other
structural work in the immediate vicinity of
the ducts or flue gas exhaust devices and
their accessories, switch the appliance off by
switching the external switch to the “OFF”
position and shutting off the gas control
valve. When the work has been completed,
ask a qualified technician to check the
efciency of the ducting and the devices.