32
1 2 3 4 5 6
Note:
The boiler has a built-in anti-short time circle
energy saving control program. in central
heating mode, it will prevent the boiler from
starting frequently in a short space of time
to save energy. So when the boiler has
just switched off, it will not start again for
several minutes even if you adjust the heating
temperature to higher level.
At the water usage point (such as basin, sink,
etc), the boiler will run and supply hot water
automatically when you open the hot water tap
regardless to if the boiler is in Central heating/
Hot water mode.
The boiler will turn off the hot water function
automatically when you close the hot water
tap ( it will continue to supply heating as
requested).
The boiler can be switched from mode (Hot
water/ Central heating) by pressing the
heating up button and the hot water up button
together for 3 seconds.
Heating
The display will show
when
the boiler has power. Press ON/OFF
button
for 5 seconds, the boiler will be turned on and
work under Central heating, and the display
will show
.If you need to
turn off the boiler, press ON/OFF
button for
5 seconds.
Setting heating temperature
Press heating temperature up
/down
button to set the temperature of central
heating (press “up” button to increase the
temperature and press “down” button to
decrease the temperature)
4).ON/OFF (Power) button (Central heating/ Hot
Water only mode)
5).Heating temperature up/down button
6).Pressure gauge
1).Timer
2).D.H.W. temperature up/down button
3).Display
To Next Page
Loading...
