29
Meter Maintenance and Troubleshooting
7
The meter is connected to a PC and a
blood glucose or control test cannot be
performed.
EITHER remove the USB cable and
perform a blood glucose or control test
OR remove the test strip and start a
data transfer.
The meter was unable to pair with a
mobile device.
Retry the pairing.
The batteries are almost out of power.
Change the batteries now. If the
symbol reappears after the batteries
have been replaced, remove the
batteries again, press and hold either
meter button for at least 2 seconds,
then reinsert the batteries.
(The error code and Err
will alternate on the
display.)
The test strip may be damaged, not
properly inserted, or was previously
used.
Remove and reinsert the test strip, or
replace it if damaged or previously
used.
83715_09767959061A.indd 2983715_09767959061A.indd 29 6/29/2021 11:31:03 AM6/29/2021 11:31:03 AM
To Next Page
Loading...
