CoaguChek XS System User Manual for Self-Testing, version 10.0 USA
77
Display Information and Symbols
The meter performs an automatic display check when
it is turned on. In case you suspect the display or parts
of it to be defective (e. g. if you have dropped the
meter), you must check by means of the display test if
the meter display works properly. If your display is not
functioning properly, do not perform further tests as
results may be misread if a segment is missing.
Contact the Roche Customer Support Center at
1-800-428-4674 in this case.
If the display check is too quick, you can put it “on
hold” by pressing and holding down the On/Off
button the next time you turn the meter on. For as
long as you keep the button pressed, the display
remains frozen.
The full display should
appear as shown at left.
To Next Page
Loading...
