RocketFish RF-HTMF19 - Step 3: Attach Horizontal Brackets

11
RF-HTMF19
STEP 3 - Attach the horizontal brackets to your TV
CAUTION: To avoid personal injury or property damage, do not use power tools.
1 Align the holes you noted on the horizontal brackets (04) with the screw holes
on the back of your TV.
2 Place the washers (
02) over the holes in the brackets that align with the screw
holes on the back of your TV, then insert the screws that you selected in
STEP 2 (
01) through the washers. Make sure that the brackets are level.
3 Add spacers (03) if you determined that spacers are required in STEP 1.
4 Tighten the screws until they are snug against the brackets. Do not over tighten.
You’ll need
02 Washers (4)
01 Screws (4)
OR
04 Horizontal TV
brackets (2)
OR
OR
OR
Phillips screwdriver
OR
OR
03 Spacers (4)