Rockwell Automation Publication 440G-UM001C-EN-P - June 2019 59
Typical Installations Appendix B
Switch Mounted to a Sliding
Guard Door
EU Declaration of Conformity
For Product Certifications, visit our website at rok.auto/certifications.
The Z (height) position is
adjusted by sliding the
actuator bracket up/down
on the profile. If the setting
gap is centered between the
minimum of 0 mm and the
maximum of 5 mm
(0.20in.), a tolerance to
misalignment of ±2.5 mm
(0.10 in.) is achieved.
The X and Y positions can
be adjusted using the slotted
holes of the mounting
bracket and appropriate
selection of the three pairs of
actuator bracket holes, once
the bracket is centered.
The tolerance to
misalignment is +/- 2.5 mm
(0.10 in.).
Mounting
bracket
440G-LZAM2
X
Z
Y
To Next Page
Loading...
