Rockwell Automation Publication 440G-UM001C-EN-P - June 2019 23
Wiring Chapter 4
1
Add the letter “S” to above catalog numbers for stainless steel connectors; for example, 889DS-F5AC-1.
Auxiliary Output
Tab le 6 shows the auxiliary output functions. The auxiliary output is a 24V
DC logic signal, whose function is dependent on the catalog number selected.
The auxiliary signal responds independently of the OSSD safety outputs. The
auxiliary output is not a safety-rated signal and must only be used to indicate
the status of the switch.
Table 6 - Auxiliary Output Function
Catalog codes for both types are explained in Catalog Numbers on page 9.
3 — 8-pin Device Patchcords
1 meter, 8-pin 889D-F8ABDM-1
2 meters, 8-pin 889D-F8ABDM-2
5 meters, 8-pin 889D-F8ABDM-5
10 meters, 8-pin 889D-F8ABDM-10
4 — 5-pin Patchcords
1 meter, 5-pin 889D-F5ACDM-1
2 meters, 5-pin 889D-F5ACDM-2
5 meters, 5-pin 889D-F5ACDM-5
10 meters, 5-pin 889D-F5ACDM-10
5 — 5-pin Cordsets
2 meters, 5-pin 889D-F5AC-2
5 meters, 5-pin 889D-F5AC-5
10 meters, 5-pin 889D-F5AC-10
Catalog Number Function Value
440G-LZS21*P** Lock Status 24V when switch is unlocked
0V when switch is locked
440G-LZS21*T** Door Proximity 24V when guard door is open
0V when guard door is closed
IMPORTANT Door proximity models: Auxiliary output changes state when the actuator is
in proximity to the switch body.
The proximity is such that the actuator is within 20 mm (0.79 in.) (measured
centerline of lock bolt to centerline of the hole in the actuator).
Can be used for door position if a latch is fitted such that a guard or door is
either open or fully closed.
To Next Page
Loading...
