Rockwell Automation FlexPak 3000 OIM

II
FlexPak 3000 DC Drive OIM User’s Guide
Chapter 6 Using the OIM to Monitor and Control the Drive
6.1 Using the OIM to Monitor Drive Outputs ..........................................................6-1
6.1.1 Description of the Monitor Mode Outputs ..............................................6-1
6.1.2 Selecting the Outputs to Monitor ...........................................................6-2
6.1.3 Using Help in Monitor Mode ..................................................................6-2
6.2 Control Source .................................................................................................6-2
6.2.1 About the Control Source ......................................................................6-3
6.2.2 Setting the Control Source.....................................................................6-4
6.3 Changing the Manual Reference Using the OIM .............................................6-4
6.4 Using the OIM to Control the Drive ..................................................................6-5
6.4.1 Starting the Drive...................................................................................6-5
6.4.2 Stopping the Drive .................................................................................6-5
6.4.3 Changing Drive Direction.......................................................................6-6
Chapter 7 Troubleshooting the Drive Using the OIM
7.1 Identifying Problems Indicated by Faults or Alarms.........................................7-1
7.2 Reviewing and Resetting Faults and Alarms ...................................................7-2
7.2.1 Reviewing the Fault and Alarm Logs.....................................................7-3
7.2.2 Resetting Faults and Alarms and Clearing the Logs .............................7-4
7.3 Using Diagnostics to Solve Drive Problems.....................................................7-5
7.4 Clearing a Programming Error Message..........................................................7-6
7.5 Determining Why the OIM is Not Communicating with the Drive.....................7-6
7.6 Replacing the OIM ...........................................................................................7-7
7.6.1 Preparing to Replace the OIM ...............................................................7-7
7.6.2 Accessing the OIM and Disconnecting It from the Regulator Board......7-7
7.6.3 Replacing the OIM Circuit Board Only...................................................7-8
7.6.4 Replacing the Entire OIM Assembly......................................................7-8
7.7 Resetting the Clock..........................................................................................7-9
Appendix A OIM Menu Structure
A.1 FlexPak 3000 Main Menu ............................................................................... A-1
A.2 Complete OIM Menu Structure ....................................................................... A-1