Maintenance
Repair
MagneMover LITE Service Manual 123
Rockwell Automation Publication MMI-UM037A-EN-P - April 2020
Replace Wear Surfaces on Pallet
The various wear surfaces on the pallet that is used with the precision locator must be replaced
once they have become worn due to extended use (typically greater than 16,000 km travel or
2 years, whichever occurs first). This procedure provides instructions to replace worn wear
surfaces on the pallet or to replace a pallet if it has become damaged.
Required Tools and Equipment
• 100-0097-30 – Loctite 243, Thread locker Anaerobic Adhesive, Blue.
• 100-2067-01 – Screw, Flat Head, M4 X 8 mm L, A4 SS, per DIN 7991 (2X).
• 100-2067-05 – Screw, Flat Head, M4 X 20 mm L, A4 SS, per DIN 7991 (2X).
• 100-2378-00 – Glue Dot, Adhesive, Hi-Tack, Semi-Perm, Lo-Profile, 0.250.
• 200-2202-00 – Preload Spacer, Compliant, Puck Center Plate, ML.
• 200-2205-00 – Center Plate, Puck, Ribs, G5, ML.
• 200-2288-00 – Replaceable Ski, ML Puck (2X).
• 200-2324-00 – Spacer, Magnet Array, ML-PL (2X).
• 200-2155-01 – Strip, Protective, Puck Bottom, Wide, UHMW (Optional).
• Isopropyl Alcohol.
CAUTION
Strong Magnets
To avoid severe injury, people with pacemakers and other
medical electronic implants must stay away from the magnet
array on the vehicles (pucks).
To avoid injury from strong magnetic attractive forces:
• Handle only one vehicle (puck) or magnet array at a time.
• Do not place any body parts, such as fingers, between a
vehicle (puck) or magnet array and any ferrous material
or another magnet array.
• Vehicles (pucks) or magnet arrays not being used must be
secured individually in isolated packaging.
To avoid damage to watches, instruments, electronics, and
magnetic media, keep metal tools, metal objects, magnetic
media (for example, memory disks/chips, credit cards, and
tapes) and electronics away from the magnet arrays.
To Next Page
Loading...
Need help?
General
